Latest and live tenders published in all country. Click on any tender to view further details.
supply of cationic column, make int srl, size l - 520mm, diameter 130mm, with top i/o ports 1/2npt f to 1/4 nptm aisi 316. body acrilic resi n transparent type . 4 bar/80 c.use for desal
supply of plummer block bearing with housing;model: sy508m;make: skf; used in york ahu at gt phase-1
supply of v-belt pulley with taper lock ; type :spb taper lock ; model: 355-2 tb 3020;2 grooves; bore:3020; pitch diameter :355 mm, shaft dia 40mm; material: cast iron; used in gt phase-1 ahu blower.
supply of plate mounted axil fan ; model; qc 454t; 0.37kw, 380v, 50hz, ip;55 flow: 100 cu/min, with gravity shutter gs 45; make dynair - ital y, test certificate required.
supply of control interface board; pb int-dr-dsp for borri charger. borri ordering code : pb518
supply of limit switch, type: xck mr 54 d1, make: telemecanique
supply of relay; over/under volt; pn. 000310 for 380v, make schleicher, type sxt12, nr.18502888, supply 250v ac, in 5a
stud m36x205l with two nuts full thread material for stud a193 b7 & for nut a194 2h mill certificate to be provided along with su
supply of grp cover; shall be in two portion with opening from the center for size 1100x 600/mm. the lifting handle shall be d-ring lathing l ocking system & cover shall be twin hinged into a grp frame and made from slip resistant like interlock design. & color will fina l ize by dewa engineer as per site requirement. the load bearing capacity not less than 250 kn hangs bolt should be 12mm stainless st eel 316l & covered with ferrule. safety arrangement shall be provided to prevent accidental closure i.e. when it is fully open the n it shall open up to minimum 120 degree to avoid sudden closure. chamber required as per attached drawing and spcification.
supply of dehumidifier unit; model:ml1100 e;voltage:3x380; frequency:50hz;kw:12.75; heater rating:11.1 kw; make:munters gmbh, origin: sweden. including all accessories and trolly along with inletand outlet hoses minimum 6meters length and flanges suiting steam turbine appli